Handmade Sink Manufacturers Share Sink Notes Analysis (Automobiles & Vehicles - SUVs & Trucks)

AUNetAds > Automobiles & Vehicles > SUVs & Trucks

Item ID 1283163 in Category: Automobiles & Vehicles - SUVs & Trucks

Handmade Sink Manufacturers Share Sink Notes Analysis


When decorating the kitchen, the sink is an essential tool in the kitchen, and many users do not pay attention to the installation specifications of the sink, which may lead to various problems in the daily use, such as the floating rust of the sink, mildew spots, etc. These are caused by not paying attention to the installation steps or incorrect installation of the sink when installing the sink. The handmade sink manufacturers below will give you a detailed introduction to the installation steps and installation precautions for the sink, and I hope to help you.

1. Reserved sink position
For the sink, we need to reserve a sink before installation. The reserved sink position needs to be designed according to the purchased sink plan, so you need to ask the merchant for the plan of the sink when you purchase it. If you don't need to know the specific size of the sink.

2. Install the faucet and water pipe
After the water tank is reserved, it is necessary to install the faucet and the inlet pipe before installing the water tank to ensure that the water tank can be used normally after installation, avoiding the rework caused by the delay and delaying the installation progress. In addition, one end of the inlet pipe on the faucet needs to be connected to the water inlet switch.

3. Put in the sink
After ensuring that the previous steps are completed, we need to put the sink into the reserved sink position on the table. After the insertion, we need to install the matching hanging piece between the table and the sink to ensure that the sink is firm and not shaken after installation. In particular, it is necessary to pay attention to whether the joint between the sink and the countertop and the water pipe is tight.

4. Install overflow hole and filter basket
For the installation of the overflow hole and the filter basket, it is necessary to pay attention to the sealing performance. It can be said that the performance of the two sealing performances is directly related to the effect of the use of the water tank. Therefore, it is necessary to check the tightness of the overflow hole and the filter basket after installation.

5. Hanging piece installation
The installation of the hanging piece is the last step of the installation of the sink. Generally speaking, when the sink is purchased, there will be a matching hanging piece. The construction personnel will select the spacing between the sink and the table to select the hanging piece, which is required during installation. Take care to avoid small gaps that cause the tank to shake and prevent water leakage in the future.

6. Detection and edge sealing
After the installation is complete, we need to test the water inlet and outlet, sealing, etc. of the sink to ensure the quality of the sink. Fill the sink with water to check for water leaks. If it should be reinstalled, drain the water and test the drain. Make sure there are no water leaks or water seepage and then seal with silicone to ensure a uniform gap between the sink and the table.

information about handmade sink manufacturers : https://www.afastainlesskb.com/product/sink/handmade-sink/


Related Link: Click here to visit item owner's website (0 hit)

Target State: Queensland
Target City : Yuyao
Last Update : 12 March 2019
Number of Views: 10
Item  Owner  : afastainlesskb
Contact Email:
Contact Phone: (None)

Friendly reminder: Click here to read some tips.
AUNetAds > Automobiles & Vehicles > SUVs & Trucks
 © 2019 AUNetAds.com
2019-03-23 (0.084 sec)